Block cipher modes of operation

Various modes of operation for block cipher usage were originally defined for DES in a US Federal Information Processing Standard (FIPS) . The most recent NIST recommendations are in "Recommendation for Block Cipher Modes of Operation"

These modes can be applied to any block cipher.

Traditional modes

In some modes, the cipher is used only for data secrecy. These are covered here. See the next section for modes which provide authentication as well.

Electronic Code Book, ECB

In Electronic Code Book mode, the cipher is just applied to each block of plaintext independently.

The disadvantage is that the same plaintext block always encrypts to the same ciphertext; this gives an enemy some information. ECB is therefore generally not used.

Cipher Block Chaining, CBC

In cipher block chaining mode, the ciphertext output from the previous block is XORed into the plaintext before encryption. Encryption of block n is then:

 cn = encrypt( pn XOR cn-1)

For this to work for n=1, an initialisation vector (IV) must be provided to act as c₀. This need not be secret, but it must be different for each message and should be random. If the same IV is repeatedly used, then if two or more messages start with the same text, they will encrypt identically for the first block or the first few blocks. This is an unnecessary weakness; using unique IVs is therefore standard practice.

CBC mode makes the encryption of any block depend on all blocks previously encrypted. A bit error in an encrypted block, such as might be caused by line noise, will cause the decryption of that block and the next to be garbled, but later blocks will not be affected. CBC is self-recovering against bit-flipping errors. However, loss of synchronisation is fatal; if even a single bit is dropped or added, then the affected block and all that follow it will be garbled. Authentication of the packet or message can prevent such problems if decryption is only applied to data that has passed authentication,

Cipher block chaining is much the most widely used mode. IPsec specifies it as the only permitted mode. PGP and TLS use it as well.

Counter, CTR

In counter mode, a counter is encrypted to generate a series of pseudo-random output blocks. It can be used to create a pseudorandom number generator or a stream cipher; if the block cipher is secure and is keyed and re-keyed appropriately, these will be secure as well.,

Counter mode is used in the Yarrow random number generator.

It is possible to re-key using some of the system output as the new key; Yarrow does this every 10 iterations, just to complicate any analysis. However, this is not enough for security if large amounts of output are required; the cipher must also be re-keyed (much less often) from an external source of genuine random numbers. The Yarrow paper demonstrates an attack after 2^keysize/3 outputs, so any use of counter mode should be externally re-keyed well before that.

Dual use modes

When a block cipher is used in a hybrid cryptosytem, a cryptographic hash is often used as well; the cipher provides secrecy and the hash provides authentication. However, this is somewhat inefficient; the system must make two passes through the data, one to encrypt it and one to hash it.

There is quite a bit of recent (roughly, since the turn of the century) work on the design of algorithms that can do both in one pass. Many of the proposed solutions take the form of new modes of operation for block ciphers. These are covered in this section.

Much of the work has been done in the context of Internet standards such as IPsec, where it addresses a significant performance issue. See RFC 3686, RFC 4106, RFC 4309 and RFC 5084.